Resolution: | 3/8 inch (10mm) |
Accuracy: | ± 10% or better, limited by resolution and tank shape |
Operating temperature range: | 0 to +60°C |
Sender materials: | 0.008″ thick glass epoxy circuit board with conformal coating for circuit protection. Laminated on the back with 3M 300LSE Bonding Adhesive |
Display mounting panel: | Black panel, approximately 102mm wide x 71mm high x 25mm deep. Panel screws to wall. Required cut-out size is 76mm wide x 46mm high |
System power requirements: | Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA |
Wiring: | Common two wire conductor (signal and ground) required from the display to each sender. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank |
LPG sender characteristics: | Display will work with an LPG sender maximum resistance of 50 ohms to 500 ohms. Display shows increasing level as resistance increase. System must be calibrated with the LPG tank full, or can be factory calibrated |